Sensors

The Duco sensors are divided into 2 families. The motion sensor and the CO², RH and IQ sensor.

The motion sensor has a communication type connector. The CO², RH and IQ sensor has a communication connector and an electrical connector with corresponding parameters. Both families belong to the category Communication Devices.

IQ unit

By using the IQ unit the Duco Systems can be set up. This unit contains a shared nested family of the Electrical panel category to connect the components with a communication connector.

To create a system, proceed as follows:

• Select the desired component to connect to the IQ unit. This must be a component that is provided with a communication connector (electronic grille, Ducobox or sensor)
• In the ribbon <panel, select Create Systems <Communication
• When the command is active select in the ribbon <panel: System Tools <Select Panel.
• Because the IQ unit is a Communication Device and uses a shared nested family of the Electrical Panel category, we can not directly select the component in the view. We can select the Panel via the Option Bar.
• In the System Browser you can check the created system.