Split Cable Trays

This function splits Cable Trays in the selection into smaller pieces and creates Union Fittings in between of them.

The Default Standard length en Minimum length of the splitted Cable Trays are set in the properties of the Cable Tray type 

   Therefore, the following project parameters should be loaded into your project according to the Witas template (Category Cable Trays):

        For annex RME_BE_NL these parameters are: BE_G Standaardlengte and BE_G Standaardlengte min 

        For annex RME_BE_FR these parameters are: BE_G Longueur standard_min and BE_G Longueur standard_min

        For annex RME_BE_EN these parameters are BE_G Standard length and BE_G Standard length_min

Remarks:

The tool tries to create Cable Trays as much as possible according to the Default Standard length.

The remains at the end of the original Cable Tray are averaged out

The tool will never create a Cable Tray smaller than the Standard minimum length